app550 eth1 dhcp relay

[mihai_balaci]

Hi all,

The AP has 2 gigabit ports: ETH0 and ETH1. on ETH0 I connect the AP to the network, and on ETH1 I was connecting another device to the network (like a dhcp relay)

I just updated my AP550 from 10.5.3 to 10.6.1.1 and the setup is broken - the connected device on port ETH1 doesn't have access to the network anymore.

Any clue ? 

[Christoph_S]

Hello @mihai_balaci,

If you downgrade back to 10.5r3 will it operate again?

Want to establish if issue with firmware or with the configs. 

What power is the AP using? CLI command: #show system power mode

Is ETH1 up?

#show interfaces

#show int eth1

ETH1 should be configured as an Access port. Please follow these instructions for same: https://extreme-networks.my.site.com/ExtrArticleDetail?an=000078279

BR,