Interface shows wrong value for transmit Power

[systemscsn]

hi,

I've been going through all of our AP650(ah) AP's and lowering the transmission power on with wifi0 and wifi1 interfaces.

I have set a the power to 10 on both interfaces for 10 AP's in a two floor building.  While the XIQ shows that 8 of the 10 AP's are showing the correct Transmission power, i have 2 AP's that are showing as Auto on wifi0, but the correct 10db on wifi1....

If i go into configuration at the device level, wifi0 is set to manual and 10db.

Which should i believe the XIQ interface, or what the device config shows?

Any ideas why this is going on?

thanks,
J.

[SamPirok]

Hey, I would believe the CLI over the Web GUI. It's likely that the GUI is just lagging, or if it doesn't catch up after about a day then it's likely a GUI bug. The only troubleshooting step I'd recommend before trying a support ticket is to fully update the APs; a complete configuration update with a reboot and moving to the latest firmware version if you aren't already there.