Looking for info related to DFS Dynamic Cost & Signal Quality Group

[w1f1n00b]

I came across the following options in CLI but can’t find any more info on them.

• dfs-dynamic-cost       Set parameters for the ACSP DFS Dynamic Cost feature
  • enable
    • Enable the ACSP DFS Dynamic Cost feature, in which all DFS channels are treated equally as non-DFS channels in terms of ACSP channel selection strategy, before radar is signal-quality-group  

• signal quality group
  • noise, rssi, snr
    • threshold
      • ex -95, -90 etc.

dfs-dynamic-cost - any idea if this is on by default when enabling DFS in the radio profile? If not, how is DFS channel selection handled otherwise?

Signal quality group - no idea what this is. what are these thresholds for?

[Paul_Wang]

"interface <wifix> dfs-dynamic-cost enable" - This is enabled by default.

Enable the ACSP DFS Dynamic Cost feature, in which all DFS channels are treated equally as non-DFS channels in terms of ACSP channel selection strategy, before radar is detected.(Default: Enabled)

http://docs.aerohive.com/330000/docs/help/english/documentation/cli_guide_ap630_ap650_ap650x-10-0r5.htm#cmd497

"interface <wifix> signal-quality-group" is used for Network 360 reporting purpose. You should not care about this normally. 

http://docs.aerohive.com/330000/docs/help/english/documentation/cli_guide_ap630_ap650_ap650x-10-0r5.htm#cmd521