11-23-2022 04:03 AM
Hi Guys,
I have a problem with LAG (LACP). When I configure command enable sharing 6 grouping 6-7 lacp on both switches, I have - in column "Agg Mbr". I have tried 3 EXOS images with versions 32.1.1.6, 31.7.1.4 and 31.1.1.3.
I see "link state" as active, "Link up transitions" with numbers but for example column "current master" is empty.
I have added port 6 to vlan Data and port is marked as *6bg.
I have tried version 31.1.1.3 in GNS3 and it is working there. Can somebody help me, why EVE-NG doesn't work? Thank You
11-23-2022 08:57 AM
This is not related to ExtremeControl. You may get more responses if the question is properly assigned.
11-25-2022 01:24 AM
Hi Zdenek, can you tell me where should I assign this topic? Thanks
11-25-2022 05:25 AM
I would ask in the "Extreme Networks > Community List > Switching & Routing > ExtremeSwitching (EXOS/Switch Engine)"
This thread is in the "Extreme Networks > Community List > Network Management & Authentication > ExtremeControl"
11-23-2022 06:03 AM
HI Matej,
I had no issues in my GNS3 lab running 31.7:
System Type: EXOS-VM
SysHealth check: Enabled
Recovery Mode: All
System Watchdog: Enabled
Current Time: Wed Nov 23 14:02:30 2022
Timezone: [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC.
Boot Time: Wed Nov 23 14:00:48 2022
Boot Count: 0
Next Reboot: None scheduled
System UpTime: 1 minute 42 seconds
Current State: OPERATIONAL
Image Selected: primary
Image Booted: primary
Primary ver: 31.7.1.4
Secondary ver: 31.7.1.4
Config Selected: NONE
Config Booted: Factory Default
Config Automatic: NONE (Disabled)
LAA MAC: Locally Administered MAC Address Disabled
* EXOS-VM.4 # show sharing
Load Sharing Monitor
Config Current Agg Min Ld Share Ld Share Agg Link Link Up
Master Master Control Active Algorithm Flags Group Mbr State Transitions
================================================================================
1 1 LACP 1 A 1 Y A 1
2 Y A 1
================================================================================
enable sharing 1 grouping 1-2 lacp