Good afternoon dear, my name is Evandro Guimarães and I'm one of the members of the IT team of the Figueira da Foz District Hospital, located in Figueira da Foz, Portugal. The reason that leads me to contact you is because we use some Enterasys equipment, namely the SSA-G1018-0652 Fiber Switch model (frimware 08.63.06.0005).
In our restructuring, we need to create redundancy between equipment, to ensure network continuity in case of equipment failure, so we need to make the aggregation (LACP) of two ports 10Gbits so that you can connect 2 switches in a stack, so we have no loop.
The problem is that I've seen dozens of articles, and even, following the respective manual of the switches, we are not able to perform the aggregation, ie, the switch accepts all commands, but the port LAG does not appear with the associated ports.
The commands are as follows:
set port vlan tg.1.1;tg.1.3;lag.0.10 500 modify-egress
set vlan egress 500 tg.1.1;tg.1.3;lag.0.10 tagged
set lacp aadminkey lag.0.10 100
set port lacp port tg.1.1 aadminkey 100
set port lacp port tg.1.3 aadminkey 100
set port lacp port tg.1.1 enable
set port lacp port tg.1.3 enable
When I do the check, the result is as follows:
show port status lag.0.10
Eventually, if I make the enquiry through the door I have no associate!
At the moment I don't have the fibres connected, is that the reason why they don't show up associated?
Can you help me, the forums don't have valid solutions.
Thank you for your attention and I hope for a brief reply.
Best regards
1 ACCEPTED SOLUTION
