I am attempting to create a stub area between a K6 and a x460-G2. I gleaned a lot of information from this post OSPF Stub between EOS and EXOS not updating routing table. However I am stuck and hoping for some direction. Here are my configs
K6
int...
Good Morning, i have a switch X450G2 with only 1 powersupply,
the ports do not send the poe so I can not connect a device requiring poe like phones or tvcc
show inline-power
Inline Power System Information
Configured ...
Hi,
On support portal, there is only A2 firmware under legacy switches. I have a B2H124-48, its firmware is
04.02.19.0008. What is the latest firmware for this model? If there is a new version, where can I find it?
Regards,
Rahman
Hi,
Currently have an issue in that the helper addresses configured under a VLAN interface on the secondary address doesn't seem to be forwarding the requests? Primary address seems to work fine.
My presumption is that requires from both primary an...
