LAG X690 between SFP and UTP

[Elena_Madrigal]

Hello i have a Stack between two switch model X690 one of then 10G fiber an other of copper switch. But when i make a lag show the following error. It is possible to make a lag between 10G copper +10 G fibber?

=========================

XXXXXXXXX # show ports 1:48,3:48 configuration no-refresh
Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
1:48 VR-Default E R OFF 10000 FULL NONE
3:48 VR-Default E A ON 10000 10000 FULL FULL SYM 3:48 UTP
================================================================================
XXXXXXXX# configure sharing 3:48 add ports 1:48

Error: Member Port 1:48 has Auto Negotiation Off while Master Port has Auto Negotiation On

Configuration failed on backup Node, command execution aborted!

===================================================

[Steven_Lin]

EXOS support mix fiber and UTP port in the same sharing group when the port speed and duplex same.

[Steven_Lin]

Sorry for provide inaccurate answer, I will try to update below article.
https://gtacknowledge.extremenetworks.com/articles/Q_A/Is-it-possible-to-create-a-LAG-with-a-combina...

[Nick_Yakimenko]

try to enable autonegotiation on 1:48