Hello i have a Stack between two switch model X690 one of then 10G fiber an other of copper switch. But when i make a lag show the following error. It is possible to make a lag between 10G copper +10 G fibber?
XXXXXXXXX # ...
Hello i am making a Link agregation : summit X690 Vs Enterasys N7.
Configuration of Summit:
configure sharing 1:1 add ports 1:1,1:2Configuration Enterasys N-7
set port vlan ge.3.24-25;lag.0.62 1 modify-egress
set vlan egress 2-100 lag.0.62;ge.3.23-...
Clients active report not showed trought GUI ( i have tried with differnt browsers) Only troguht ssh,Others reports works successful via GUI. If i restart the controller works some time but with the user active increase the report is not showe...
Hello i have currently two V2110 controller in HA. And we have purchased 2 – C5210s and we be installing them soon. My question is how do I migrate them over the C5210? I do not believe that I cannot simply back up the V2110(Config’s, CDRs, Logs, A...
After looking into this i have found that it is not possible to create a lag with mixed UTP and fiber ports.
Auto-negotiation is mandatory for 10GbBase-T according to the 802.3 standard, while it’s not possible on fiber due to the p...
Hello i also tried to setup 3:48 to auto OFF but it not supported the following error says:
XXXXXXX # configure ports 3:48 auto off speed 10000 duplex full
Error: Auto negotiation off is not supported on port 3:48 at 10 Gbps speed.
No steven All sfp are 10Gb . Why ?
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red