cancel
Showing results for 
Search instead for 
Did you mean: 

LAG X690 between SFP and UTP

LAG X690 between SFP and UTP

Elena_Madrigal
New Contributor II
Hello i have a Stack between two switch model X690 one of then 10G fiber an other of copper switch. But when i make a lag show the following error. It is possible to make a lag between 10G copper +10 G fibber?

=========================

XXXXXXXXX # show ports 1:48,3:48 configuration no-refresh
Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
1:48 VR-Default E R OFF 10000 FULL NONE
3:48 VR-Default E A ON 10000 10000 FULL FULL SYM 3:48 UTP
================================================================================
XXXXXXXX# configure sharing 3:48 add ports 1:48

Error: Member Port 1:48 has Auto Negotiation Off while Master Port has Auto Negotiation On

Configuration failed on backup Node, command execution aborted!

===================================================



12 REPLIES 12

Hello i also tried to setup 3:48 to auto OFF but it not supported the following error says:
==============
XXXXXXX # configure ports 3:48 auto off speed 10000 duplex full
Error: Auto negotiation off is not supported on port 3:48 at 10 Gbps speed.
Configuration failed on backup Node, command execution aborted!
* XXXXXX #

Elena_Madrigal
New Contributor II
Hello i cant change the auto neg in 1:48, Is the first that i have tried ...
======================
********** # configure ports 1:48 auto on speed 10000 duplex full
Error: Auto negotiation is not supported on port 1:48 at 10G speed

Configuration failed on backup Node, command execution aborted!
*********
Also i have a LAG between to 10G UTP ports and works perfect, only fails when i add to the sharing group the 10G fiber port.

No steven All sfp are 10Gb . Why ?

Port Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
1:1 VR-Default E R OFF 10000 FULL SF+_SR
1:2 VR-Default E R OFF 10000 FULL SF+_SR
1:3 VR-Default E R OFF 10000 FULL SF+_SR
1:4 VR-Default E R OFF 10000 FULL SF+_SR
1:5 VR-Default E R OFF 10000 FULL SF+_SR
1:6 VR-Default E R OFF 10000 FULL SF+_SR
1:7 VR-Default E R OFF 10000 FULL NONE
1:8 VR-Default E R OFF 10000 FULL SF+_SR

Is there any 1G SFP had been installed on the switch?

mischoe
New Contributor
The error indicates that one link has auto negotiation on, the other off. Tun on auto negotiation on on both 10Gbit links.
GTM-P2G8KFN