I have checked the logs and theres no error like this
LACPDU. Actor: System ID 0x0000, 00-04-96-44-05-d0; Key 0x0efd; Port ID 0x0000, 0x0fea; State 0x0d. Partner: System ID 0x8000, ca-fe-22-42-be-ef; Key 0x0001; Port ID 0x8000, 0x0001; State 0x04. Collector: Max delay 0.
or any error to do with port-channeling
only message i see in logs is the below
12/19/2017 17:58:06.54 Slot-1: Port 3:48 link down
12/19/2017 17:57:10.14 Slot-1: Port 1:2 is UP with speed 1000, Add to aggregator 1:2 with speed: 1000
12/19/2017 17:57:10.14 Slot-1: Port 1:2 link UP at speed 1 Gbps and full-duplex
12/19/2017 17:56:47.69 Slot-1: Port 3:48 is UP with speed 1000, Add to aggregator 1:2 with speed: (down)
12/19/2017 17:56:47.69 Slot-1: Port 3:48 link UP at speed 1 Gbps and full-duplex
12/19/2017 17:56:37.49 Slot-1: Port 3:48 is Down, remove from aggregator 1:2
12/19/2017 17:56:37.49 Slot-1: Port 3:48 link down
12/19/2017 17:41:27.45 Slot-1: Port 3:48 is UP with speed 1000, Add to aggregator 1:2 with speed: (down)
12/19/2017 17:41:27.45 Slot-1: Port 3:48 link UP at speed 1 Gbps and full-duplex
A few seconds after plugging the second port the switch starts to slow down in between commands as soon as i disable the port the switch runs normally again