ExtremeSwitching (EOS) - Page 40 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

Apple devices triggering HostDos icmpSize

Hi, recently I have seen some Apple devices triggering the HostDos icmpSize check (set to the default size limit of 1024) on an S-Series: Event(Notice) for - HostDoS[6] Attack ( icmpSize ) detected on vlan.0. InPort() LEN(1398) DA() SA() C-TAG(810...

How to load share IPv6 packets on LAG interfaces?

Hello everyone, I have 2 Extreme switches that have following spesification: Software version: EXOS 21.1.3.7 Hardware version: Summit X670 G2 48X I need to make a load sharing on LAG interfaces based on IPv6 headers. When I try to configure load shar...

Is it possible to view an address range instead of a specific address byte using debug hal show gbic_i2c ?

Working with an Extreme x460g2-48p-10g4 and trying to take a look at some of the transceiver outputs for a few optics. Is it possible to view an address range instead of a specific address byte using debug hal show gbic_i2c ? Seems to only let me d...

Have a 7100 series switch, what type of cables does it take and where can I fnd them on the extreme site.

Hello I'm new to extreme switches. Have a 7100 series switch, what type of cables does it take and where can I fnd them.

After reboot, in X620-x16 switch link down with SFP mini-GBIC

I have a problem with switch extreme X620-16T (10G) (IMG 21.1.3.7), SFP transceivers are used (therefore at 1G). I do the following steps: - Set auto negotiation to off, speed 1000, full duplex, I save the configuration - I enter the transceiver in t...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN