RESOLVED - RADIUS not working
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-02-2021 08:41 AM
I have a set of C-Series switches that are no longer working with RADIUS for some reason. This was working at one point, but is no longer now and I am not sure what changed.
If I run a Wireshark at my RADIUS server I can see the request come in and get accepted:
On the SSH session I see an access denied message:
When I review the console session I see the following:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-05-2021 04:36 PM
@Doug ​I did have the correct rule in place. Thank you.
The problem ended up being that I also had a rule in my RADIUS server for EXOS switches (https://extremeportal.force.com/ExtrArticleDetail?an=000078945). In the RADIUS server ...this works like an ACL. I had to move the EXOS rule below the EOS rule and logins started working again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-04-2021 09:06 AM
The policy on the RADIUS server must be configured to send back a filter-ID with the accept packet. See below for syntax and options.
Filter ID:
Enterasys:version=1:mgmt=access-mgmtType
Options:
access-mgmtTypes supported are: ro (read-only), rw (read-write), and su (super-user).
Director, Technical Support / Extreme Networks
