05-13-2019 12:47 PM
03-27-2023 03:21 AM
1 # unconfigure switch all Restore all factory defaults and reboot? (y/N) Yes All stacking configuration parameters have been reset to default values. Removal of the alternate-ip-address will take effect immediately. Automatic priority will take effect at the node role election time.
03-27-2023 11:54 PM
Hello Daisy8365,
Thank you for your suggestion. I followed your solution and restored all configurations, including stack configurations, to factory settings. I then made some configurations, saved them to primary.cfg, and rebooted the switch. All of the configurations remained after the reboot.
However, when I unplugged the power cable from the switch and left it without power overnight, the same issue occurred. Upon booting up, the switch had no configuration and started with the initial wizard.
Thanks you.
Kind regards,
03-30-2023 05:31 AM
If after unplugging the power plug the configuration is gone, then it means in 95% of the times that the CMOS battery has died and NVRAM cannot be saved anymore.
03-24-2023 02:10 AM