Error External Table Tuning Failed(-51) from HAL on CardExec INIT(5)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-19-2016 03:24 PM
Card 8900-G48X-xl failing with "Error External Table Tuning Failed(-51) from HAL on CardExec INIT(5)."
I am running version 12.5.4.5 on the MSM (MSM-48C) so the card should be happy with it at least I believe that it should be.
I have swapped out the RAM (with known good) on the card with no change.
Is this card just dead?
I am running version 12.5.4.5 on the MSM (MSM-48C) so the card should be happy with it at least I believe that it should be.
I have swapped out the RAM (with known good) on the card with no change.
Is this card just dead?
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-19-2016 08:10 PM
Extended Diags on the MSM past with flying colors.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-19-2016 08:10 PM
Hmm. Unfortunately, that's no guarantee there isn't a HW failure. The diagnostics code has improved with later and later versions of EXOS.
As Drew mentioned, there is one occurrence of this error in our internal bug tracker on a 12.5.x version, and this does smell like a HW failure...but it might be worth it to move to EXOS v15.6.4.2-patch1-7 to see if the error recurs/newer diagnostics code can pick up a failure.
As Drew mentioned, there is one occurrence of this error in our internal bug tracker on a 12.5.x version, and this does smell like a HW failure...but it might be worth it to move to EXOS v15.6.4.2-patch1-7 to see if the error recurs/newer diagnostics code can pick up a failure.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-19-2016 07:27 PM
Have you tried running diags on that MSM?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-19-2016 06:10 PM
Replaced the RAM per my Boss telling me to try it since I was getting this error with it. The Original RAM is back in with no change. I did notice that while the card is loading if I show the slot the download % will cycle about 5 times from 50 - 100 until the card goes to a failed status.
