ExtremeSwitching (EXOS/Switch Engine) - Page 195 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Summit x430-24t firmware upgrade

Hello, i have some old switches model “summit X430-24t” i am trying to reset them to the factory defaults but i can’t use the command “config none” and it seems it’s not possible to restore factory defaults at the current firmware version ( 1.0.1.1 )...

In EXOS Switches may I use the native stacking ports for MLAG links between two boxes?

Hi, if I’ve got a couple of X465 - 24S that have each 2 x 4 0 GBase-X QSFP+ dedicated stacking ports, may I use this two ports for MLAG link between the two switches instead of use these for stacking or are dedicated only for the stacking?

Looking for assistance in RingV2 configuration on ISW fiber loop,

Looking for assistance in RingV2 configuration on ISW fiber loop- total of 8 ISW units.. This is replacing other industrial switches that set the ring up by spanning tree. What is the best RIngV2 configuration? I have 2 switches that can communicate ...

MLAG setup - looks like hitting a L2 loop

Hello, We tried to set up a MLAG between 2 x670 switches and once we enabled the second "leg" (port 41 on sw1) looks like we did hit a loop. Unfortunately it's a production network and we are very limited in opportunities to reproduce it. MLAG rela...

DHCP helper

Hello, We run a single core (X690) with edge switches throughout our network. I’ve been tasked with setting up a new NAC (Network Address Control) tool. Per the setup instructions for the tool, we need to setup dhcp helpers for all our vlans. Howev...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN