Hi , i have a problem whith ACL!!! Help me please!!!

[Alexey_shaverne]

I HAVE A PROBLEM WITH CONFIGURING acl TO THE PORT. I have summit X440G2-48p-10G4 separately and also have a stack of 5 slots. On the switch, the setting is applied, but not on the stack, says a syntax error, but the code is the same everywhere. And when typing the "check policy" command, it answers Policy file check successful. What can be wrong ? The firmware is the same there and there)

This is stack

This is Switch

This is log of the Stack

[Necheporenko__N]

Hello Alexey,

Check if your stack has enough hardware resources to install this ACL.

show access-list usage asl-slice port <port_#>

Best Regards,

Nikolay

[slewfoot2xm]

I know when setting up syslogging, you have to add the slot # to the commands to tell it which switch in the stack it’s supposed to be applied to.   It’s probably a similar requirement.