How to configure EAPS primary or secondary port, if this port belong to a LAG?

[Edison]

Hi, I'm doing a test lab, and I want to make a LAG to participate ein a EAPS domain and I noticed that you can put many ports as primary or secondary, so I was wondering if I have to put all the ports that belong to the LAG or I only put the master port,In case its only necessary to put the master port what is the purpose of the command to put a list port. Thanks in advance.

[Eric_Burke]

Once you set up sharing, you only need to add the master port to the EAPS config. For example, I have a client where we're running LACP on 1:47 and 2:47 as well as another on 1:48 and 2:48 (the 1: switches are the master ports). My Eaps config is pretty simple:

create eaps EapsCampusRing1
config eaps EapsCampusRing1 mode master
config EapsCampusRing1 primary port 1:47
config EapsCampusRing1 secondary port 1:48
config EapsCampusRing1 add control vlan V4001-EapsCampusCtrl1

config EapsCampusRing1 add protected vlan default

config EapsCampusRing1 add protected vlan V10-Lan1

config EapsCampusRing1 add protected vlan V11-LegacyLan1

config EapsCampusRing1 add protected vlan V60-WifiPrivate1

config EapsCampusRing1 add protected vlan V67-WifiProvis1

config EapsCampusRing1 add protected vlan V68-WifiGuest1

config EapsCampusRing1 add protected vlan V70-Voip1

config EapsCampusRing1 add protected vlan V79-Backup1

enable eaps

enable EapsCampusRing1

Eric