Initial setup on X440-g2-24p Can't ping between devices with static ip's on ports 2 and 3 (or any others)

[Michael_McNEany]

Initial setup, Out of Box configuration... Using the default VLAN, I can't ping between two statically set ips on devices attached to ports 2 and 3. (or any other two ports)
I have:
configure vlan default add ports 1-28
configure vlan default ipaddress 192.168.10.15 255.255.255.0
enable ip forwarding vlan default
configure iproute add default 192.168.10.1
configure bootprelay add 192.168.10.14 vr VR-Default
enable bootprelay ipv4 vlan Default

The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch.

[Michael_McNEany]

This looks like my problem... Although I have Patch 1-5, I still see:
disable flooding all_cast port 1
On ports (1->28)

[Michael_McNEany]

EXOS ver 21.1.1.4
Patch 1-5
I'll check out the link. Thanks!

[Drew_C]

Regarding patch1-5, it sounds like there are some special circumstances spelled out in the Field Notice that I didn't see. I think this section explains what you experienced:

With patch 1-5, if the switch boots and the following conditions are true, ZTP can still disable flooding after it can resolve extremecontrol (DNS) and can connect to EMC (Netsight)

1. Switch/Controller can DNS resolve "extremecontrol[.searchdomain]", "extremecontrol.extremenetworks.com" or "devices.extremenetworks.com"
2. If one of these is responding, then try to connect to it
3. Flooding is then disabled

[Drew_C]

Glad to hear that you were able to get this working. Hopefully it wasn't too frustrating.
Also glad to see that you joined The Hub just to post this question - welcome to the community!

-Drew

[Michael_McNEany]

Ha! Came here to report that I got it working with exactly this command. Thanks to the link you handed off! It looks like that patch 1-2 bug is still sorta there in patch 1-5. It is switching now though! Thanks!