Create Date: Jul 24 2013 9:07PM
I am trying to configure IPFIX on an x460 and read the flow data in solarwinds NTA but receiving the following error (NTA error):
NetFlow Receiver Service [servername] received an invalid IPFIX template with ID 265 from device
After looking at the data being sent to the collector I seem to be missing both the INPUT_SNMP and OUTPUT_SNMP information that NTA relies on, (presuming this is the issue, please correct me if I am wrong) how do you configure the switch to provide the missing data?
current IPFIX config:
configure ip-fix ip-address xxx.xxx.xxx.xxx protocol udp L4-port 2055 vr "VR-Default"
configure ip-fix source ip-address xxx.xxx.xxx.xxx vr "VR-Default"
configure ip-fix ports 47 ingress-and-egress
enable ip-fix ports 47 ipv4
configure ip-fix ports 48 ingress-and-egress
enable ip-fix ports 48 ipv4
Show ip-fix
Global IPFIX State: Enabled
Domain: 0
Source (Exporter) IP: xxx.xxx.xxx.xxx Virtual Router: "VR-Default"
Collector IP: xxx.xxx.xxx.xxx
Transport Protocol/Port/State: UDP, Port 2055, NA
Flow Keys:
IPv4: "Source-IP" "Source L4 Port" "Dest-IP" "Dest L4 Port" "L4 Protocol" "TOS"
Unused:
IPv6: "Source-IP" "Source L4 Port" "Dest-IP" "Dest L4 Port" "Next Header" "TOS" "Flow Label"
Unused:
Non-IP: "Source MAC" "Dest MAC" "Ethertype" "VLAN ID" "Priority" "Tagged"
Unused:
IPFIX Enabled on Port(s): 47-48
Any help/recommendations much appreciated!
Thanks
(from Keith_Betts)
