Showing results for 
Search instead for 
Did you mean: 

lacp aruba

lacp aruba

New Contributor
When using LACP with Aruba controller after a few days it became intermittent. Is there anyone experienced this ? This is my sample config

Extreme Employee
Elvin, can you check the following outputs when the issue occurs and determine whether the ports are active/ready, if there are any link up transitions, the show log output tells us if any ports in the LAG went down to either a local or remote fault, or any errors under the LACP counters output?

This will help us isolate whether if it is a port going down or if the issue is with the LAG.

# show sharing Load Sharing Monitor Config Current Agg Min Ld Share Dist Ld Share Agg Link Link Up Master Master Control Active Algorithm Flags Group Mbr State Transitions ================================================================================ 1 LACP 1 L2 A 1 Y A 1 L2 2 Y A 0 ================================================================================ Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback
# show lacp counters LACP PDUs dropped on non-LACP ports : 0 LACP Bulk checkpointed msgs sent : 0 LACP Bulk checkpointed msgs recv : 0 LACP PDUs checkpointed sent : 0 LACP PDUs checkpointed recv : 0 Lag Member Rx Rx Drop Rx Drop Rx Drop Tx Tx Group Port Ok PDU Err Not Up Same MAC Sent Ok Xmit Err -------------------------------------------------------------------------------- 21 21 2 0 0 0 2 0 22 2 0 0 0 2 0 ================================================================================The show log will help with any port down/up and sharing transitions.