Missing "enable stacking"

[EtherNation_Use]

Create Date: Nov 22 2012 2:27PM

Hi,

I have two X650 switches and I want to build a stack. So I connect the two nodes by the stacking cables and try to run the easy setup. But the command "enable stacking" isn't available.

Version: 12.6.2.10-patch1-15

Does anyone have an idea?

Thanks
Falk (from Falk_Fischer)

[EtherNation_Use]

Create Date: Jan 7 2013 11:30AM

Hi Falk,

Have you run the command

Configure stacking easy-setup

first? Enable Stacking and show stacking, if I remember correctly will only 'show up' as commands after you've run the above command first and then rebooted when prompted. (from Shaun_Kent)

[EtherNation_Use]

Create Date: Dec 18 2012 11:46PM

Can you do a show tech capture the output and upload the file?

p (from Paul_Russo)

[EtherNation_Use]

Create Date: Dec 17 2012 9:47AM

Hi,

sorry about the delay.
I did run "run diagnostic extented", but there are no errors.
I can't run a command to show me the stacking-protcol, because the "sh stacking" commands are missing too. 😞

thank you.

best regards
Falk (from Falk_Fischer)

[EtherNation_Use]

Create Date: Dec 4 2012 11:45PM

Check to see if enhanced stacking is enabled on both switches. The 650 comes standard with standard stacking.

p (from Paul_Russo)