ExtremeSwitching (EXOS/Switch Engine) - Page 13 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Error: Refresh failed for policy xxx - ACL install operation failed

Hello community,trying to refresh one of our policies, but I am getting this error. Have you met similar problem? I tried to find out, what this error means. But without success. Error: Refresh failed for policy 'xxx'- ACL install operation failed -...

Can we put multiple source address in the Access list polciy

can we make access policy with multiple source address since i am trying to do this but it is giving error in policy check

Resolved! EXOS on GNS3 not booting past BusyBox

Trying to boot EXOS v32.6.3.126 on GNS3 v2.2.50 running as a VM on Hyper-V and cannot get past BusyBox. I don't see anything on the tutorial site about this. The only warning I see during boot is about the CPU:Warning. Could not determine the CPU Fam...

Resolved! Firmware double check on device

Hi, anybody here who can tell me the CLI command and the place where a new Firmware is stored?Something like (dir Flash: from Cisco) i am not able to verify that the new firmware is stored on the device (x440-g2)aprreciate your helpKR Uwe

Resolved! Dynamic Port Addition to Vlans for DHCP Snooping

We have a very fluid environment when it comes to port to vlan assignment. I see that using the command " enable ip-security dhcp-snooping vlan STUDENT_ITTSTAFF_849 ports all violation-action drop-packet block-port duration 15" enables dhcp-snoopin...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN