Missing "enable stacking"
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-07-2014 09:57 PM
Create Date: Nov 22 2012 2:27PM
Hi,
I have two X650 switches and I want to build a stack. So I connect the two nodes by the stacking cables and try to run the easy setup. But the command "enable stacking" isn't available.
Version: 12.6.2.10-patch1-15
Does anyone have an idea?
Thanks
Falk (from Falk_Fischer)
Hi,
I have two X650 switches and I want to build a stack. So I connect the two nodes by the stacking cables and try to run the easy setup. But the command "enable stacking" isn't available.
Version: 12.6.2.10-patch1-15
Does anyone have an idea?
Thanks
Falk (from Falk_Fischer)
6 REPLIES 6
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-07-2014 09:57 PM
Create Date: Jan 7 2013 11:30AM
Hi Falk,
Have you run the command
Configure stacking easy-setup
first? Enable Stacking and show stacking, if I remember correctly will only 'show up' as commands after you've run the above command first and then rebooted when prompted. (from Shaun_Kent)
Hi Falk,
Have you run the command
Configure stacking easy-setup
first? Enable Stacking and show stacking, if I remember correctly will only 'show up' as commands after you've run the above command first and then rebooted when prompted. (from Shaun_Kent)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-07-2014 09:57 PM
Create Date: Dec 18 2012 11:46PM
Can you do a show tech capture the output and upload the file?
p (from Paul_Russo)
Can you do a show tech capture the output and upload the file?
p (from Paul_Russo)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-07-2014 09:57 PM
Create Date: Dec 17 2012 9:47AM
Hi,
sorry about the delay.
I did run "run diagnostic extented", but there are no errors.
I can't run a command to show me the stacking-protcol, because the "sh stacking" commands are missing too. 😞
thank you.
best regards
Falk (from Falk_Fischer)
Hi,
sorry about the delay.
I did run "run diagnostic extented", but there are no errors.
I can't run a command to show me the stacking-protcol, because the "sh stacking" commands are missing too. 😞
thank you.
best regards
Falk (from Falk_Fischer)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎01-07-2014 09:57 PM
Create Date: Dec 4 2012 11:45PM
Check to see if enhanced stacking is enabled on both switches. The 650 comes standard with standard stacking.
p (from Paul_Russo)
Check to see if enhanced stacking is enabled on both switches. The 650 comes standard with standard stacking.
p (from Paul_Russo)