need help For Extreme X450e-48P switch configure UDP data
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-22-2018 08:02 AM
Extreme Switch X450e-48p help
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-22-2018 09:07 AM
ok i will do then i will reply after testing it
tommorrow i will go to the site where i installed it
tommorrow i will go to the site where i installed it
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-22-2018 08:41 AM
Thank you for description.
I guess the issue is with multicast. the default behavior on EXOS switch is that multicast is not passing through. Enable IGMP snooping on the vlan. Commands should look like:
enable igmp snooping "Default" where "default" is the vlan name where you have the multicast traffic.
Z.
I guess the issue is with multicast. the default behavior on EXOS switch is that multicast is not passing through. Enable IGMP snooping on the vlan. Commands should look like:
enable igmp snooping "Default" where "default" is the vlan name where you have the multicast traffic.
Z.
Regards
Zdeněk Pala
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-22-2018 08:20 AM
Sir I have 8 Udp Adrress data Carrying each Ip 40 Mbps From 8 encoder ts over udp ip output
The data on switch 2,3,4,5,6,7,8,9 ports are showing. I want to carry my al udp streaming ip address over 1 number port of switch. theproblem i am facing that the video in traffic is showing on switch but video out traffic is not passing through any port of switch. i do not know how to configure udp data on switch. That is my cable tv headend multicast ip addresss
The data on switch 2,3,4,5,6,7,8,9 ports are showing. I want to carry my al udp streaming ip address over 1 number port of switch. theproblem i am facing that the video in traffic is showing on switch but video out traffic is not passing through any port of switch. i do not know how to configure udp data on switch. That is my cable tv headend multicast ip addresss
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-22-2018 08:12 AM
If you want help from the community then you need to define your problem.
If you want help from the company then contact technical assistance center.
Not sure how to proceed with the problem you described.
Good luck!
If you want help from the company then contact technical assistance center.
Not sure how to proceed with the problem you described.
Good luck!
Regards
Zdeněk Pala
