Greetings!!!
I ran into a peculiar problem, where I am unable to unconfigure a switch that was part of an existing stack. Though, the switch was removed from the stack physically but it was not un-configured logically.
1. I tried un-configuring the stack.
2. Un-configuring the switch
After the reboot I saw that though there was no configuration in the switch but I can see the LED panel showing the same stack ID being shown that was assigned to it while it was a part of the stack.
I tried turning off the master capability - Didn't work.
I tried doing a factory reset - Configuration was removed but still it was showing slot no.2
in the bootrom I tried doing a config none. - it doesn't accept the command.
I tried upgrading the switch - the partition shows the same image that it was loaded with. (current ver 12.7.1.3)
I did a TFTP to use a new configuration file., through the file was in place. I am unable to use it.
I am just not able to get rid of the stack config thats in the switch.
I must be missing something very silly.
Regards
Manish
