This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
cancel
Turn on suggestions
Showing results for 
Search instead for 
Did you mean: 

Password not working after applying configure failsafe admin permit all command

Password not working after applying configure failsafe admin permit all command

Aneeq_Zia
New Contributor

‎03-14-2017 06:08 PM

Initially I configured admin password and it was working fine on x460 switch. As soon as I applied configure failsafe admin permit all command, password is no more working....?
0 Kudos
12 REPLIES 12

Sumit_Tokle
Contributor

‎03-14-2017 08:50 PM

Note that in EXOS 21.1 and higher, a one-time failsafe exists. For information on this process, see How to access an EXOS switch using a one-time failsafe password
0 Kudos

Ram3
Extreme Employee
In response to Sumit_Tokle

‎03-14-2017 08:50 PM

Sounds good. Please make sure to configure it as per provided article.
0 Kudos

Aneeq_Zia
New Contributor
In response to Sumit_Tokle

‎03-14-2017 08:50 PM

yes, "config none" and then "boot" worked for me....
0 Kudos

Aneeq_Zia
New Contributor
In response to Sumit_Tokle

‎03-14-2017 08:50 PM

actually I tried "Config none" and than "Reboot", I think I should Try "boot" after "config none"
0 Kudos
li.common.scroll-to.top
GTM-P2G8KFN