SFP (SX Media) not activating on 15.7.1.4

[Tino]

On a X460G2-48p-GE4 the SFP ports wont activate after I upgraded the firmware from 15.6.2.12 to 15.7.1.4

If I downgrade to 15.6.2.12 the port starts up again and the uplink connects to the core switch.

I checked the release notes and cannot find any info, on the logs it when I pull the sfp out and put it back in it just shows:

04/07/2015 14:42:14.33 : Media SX is inserted into Port 49

The SFP's were bought from Enterasys and used on C5 switches. The make on the SFP's are JDSU (JSP-12S0AA1) PN 52P6529

[Tino]

Thank you for the reply Bill,
Primary ver: 15.7.1.4

Output:

X460G2-48p-G4.1 # show ports 49 no-refresh
Port Summary
Port Display VLAN Name Port Link Speed Duplex
# String (or # VLANs) State State Actual Actual
==================================================================
49 Default E R
==================================================================
Port State: D-Disabled, E-Enabled
Link State: A-Active, R-Ready, NP-Port not present, L-Loopback,
D-ELSM enabled but not up
d-Ethernet OAM enabled but not up

X460G2-48p-G4.2 # debug hal show optic port 49
Port 49
SFP or SFP+: SFP
Signal: present
TX Fault: no
SFP/SFP+ Vendor: JDS UNIPHASE
SFP/SFP+ Part Number: JSP-12S0AA1
SFP/SFP+ Serial Number: F71443470699
SFP/SFP+ Manufacture Date: 07040901
SFP/SFP+ Type: SFP/SFP+
Connector: LC
GE Compliance: 1000BASE-SX
Wavelength: 0

Working output:

Secondary ver: 15.6.2.12
patch1-1

X460G2-48p-G4.1 # show ports 49 no-refresh
Port Summary
Port Display VLAN Name Port Link Speed Duplex
# String (or # VLANs) State State Actual Actual
==================================================================
49 Default E A 1000 FULL
==================================================================
Port State: D-Disabled, E-Enabled
Link State: A-Active, R-Ready, NP-Port not present, L-Loopback,
D-ELSM enabled but not up
d-Ethernet OAM enabled but not up

X460G2-48p-G4.2 # debug hal show optic port 49
Port 49
SFP or SFP+: SFP
Signal: present
TX Fault: no
SFP/SFP+ Vendor: JDS UNIPHASE
SFP/SFP+ Part Number: JSP-12S0AA1
SFP/SFP+ Serial Number: F71443470699
SFP/SFP+ Manufacture Date: 07040901
SFP/SFP+ Type: SFP/SFP+
Connector: LC
GE Compliance: 1000BASE-SX
Wavelength: 0

[Bill_Stritzinge]

Tino,

There shouldn't be any issues but obviously there is... can you run the following command for both versions to me?

debug hal show optic port

Thanks,

Bill