ExtremeSwitching (EXOS/Switch Engine) - Page 109 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! L3 and L2 Connection issue

I have one x590 core I configureed vlans and defined the DHCP and vlan IPS I have three stacked ers3626 and I configured vlans on them and used as L2 I cannot reach the core.Any steps I just want to have a data vlan in L2 and route the traffic to int...

Can we connected Extreme 5520 to Avaya 5650 via Fiber

I’m a new network admin and we have some older Avaya 5650TD-PWR and Avaya 4850GTS-PWR+ along with new Extreme 5520. I was needing to know if I am able to use an Extreme 5520 as a master and cascade my older Avaya switches via fiber connections?

memory is gradually clogged by the pim processMemory

At Node 4 BDX8, the main traffic is CCTV multicast. Routing between BDXs is done using OSPF and PIM-SM. As a result, the memory gradually fills up, causing the management module (MM) to reboot. Why this can happen?BDX1:System Memory Information------...

Resolved! how do i redistribute static route into ospf?

On our two 690 cores, I have a static route for 192.168.56.0/24 pointed to a vpn firewall that has a connection to the internet. Vpn users connect to the device and the device has a static route back to our core. Our core has OSPF and can get to ...

Extreme Black Diamond X8 Chassis Memory problem

hello,ı have Extreme Black diamond X8 chassis with “ ExtremeXOS version 16.2.4.5 16.2.4.5-patch1-8 “ version. I got an worning on logs about memory as below;09/16/2021 11:33:08.23 <Warn:HAL.Sys.Warning> MM-B: Sys-Health-Check Card B is low on DMA Me...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN