Single EAPS ring, master node in INIT fail time-out

[Massimiliano_T1]

Master node goes in INIT status fail time out.

I have a single ring with a correct VLAN data mapping, VLAN control and no storm(broadcast).
If I use specific ports master node goes in Complete or Failure(if rings open) and It means that PDU for Healt Check, Link UP or DOWN is running.
If I use other ports with same VLAN master node in the ring goes in INIT fail time-out

I need to know how to investigate issue and kind of potential root causes

[Raymond_van_Dij]

Hi Massimiliano,

is the issue reported still relevant, if it is please share the requested information.
If not please let us know too.

Regards,

Raymond van Dijk

[Henrique]

Hi Massimiliano,

Can you please share the network diagram and EAPS/Vlan configuration?

Based on that we can suggest some actions/ideas to troubleshoot.

[Massimiliano_T1]

Control VLAN is perfect on the right ports....I configured IP Interfaces to verify if my eyes see wrrong configuration....I can ping all interfaces in control VLAN.
I have 3 different city with same topology, vlan and configuration and only in this doesn't work.
Control VLAN and data VLAN are correct.
What is funny if I use other ports of the same switches moving the cabling It works.
It seems few port are discarding EAPS PDU and Master node doesn't receive EAPS healt-PDU and Link down so It never starts EAPS status remaining in "Init" state with flag "F"(Fail-over timout)

If I close ther ring the healt-check EAPS PDU triggers the storm due to missing Master status.

Thank you for your replies

[BrandonC]

One more check would be to run ELRP on the control VLAN. In this case, you want ELRP to report a loop (contrary to most times you run ELRP). If it does not report a loop, the control VLAN is likely misconfigured somewhere along the ring.