Hi,
I would just want to ask how to configure back-up role in switches configured as stacked. See below output:
show switch
SysName:
SysLocation:
SysContact: support@extremenetworks.com, +1 888 257 3000
System MAC: 02:04:96:83:4E:A1
System Type: X450a-48t (Stack)
SysHealth check: Enabled (Normal)
Recovery Mode: All
System Watchdog: Enabled
Current Time: Wed Jul 23 14:13:17 2014
Timezone: [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC.
Boot Time: Fri Oct 11 10:55:01 2013
Boot Count: 24
Next Reboot: None scheduled
System UpTime: 285 days 3 hours 18 minutes 16 seconds
Slot: Slot-1 * No Backup
------------------------ ------------------------
Current State: MASTER
Image Selected: primary
Image Booted: primary
Primary ver: 15.3.2.11
patch1-2
Secondary ver: 12.5.4.5
Config Selected: sw2-stack.cfg
Config Booted: sw2-stack.cfg
sw2-stack.cfg Created by ExtremeXOS version 15.3.2.11
1114713 bytes saved on Wed Jul 9 14:47:31 2014
Slot-1 PIDC-CORE-CHSW-02.7 #
Node MAC Address Slot Stack State Role Flags
------------------ ---- ----------- ------- ---
*00:04:96:83:4e:a1 1 Active Master CA-
00:04:96:83:4e:b5 2 Active Standby CA-
00:04:96:83:4e:a2 3 Active Standby CA-
00:04:96:83:4e:a8 4 Active Standby CA-
thank you,
James
