ExtremeSwitching (EXOS/Switch Engine) - Page 47 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

X435-24P-4S

Stumbled today across something:All access switches, X435-24P-4S, at one of our costumers locations are assigned to a network policy only used for wireless management.XIQ Agent: 0.7.5EXOS: 32.3.1.11Has anyone a hint for what may have happened?Maybe f...

Resolved! Minimum Switch Configuration

Hello Community -I am looking for your help. I am new to using Extreme Networking devices. I am wanting to craft a standard template for myself but mainly for others to learn off of. I am looking for building out the most standard configuration ne...

Resolved! elrp-client on 5000 series?

So we are putting a bunch of new Extreme 5520's in and we use ELRP to detect loop traffic. I want it to log-and-trap so that our ExtremeCloud IQ site engine can send me an alarm and I would typically input the following command:configure elrp-client ...

Resolved! L2 communication between different network segments

Is it possible to communicate between two different network segments within a single vlan? Both devices on VLAN1, untagged. 10.9.10.10/24 communicating with 192.168.1.33/24 via layer two communication. Is this possible?Just to clarify a bit further...

OSPFv3

How to advertise default route to a OSPFv3 neighbor?In OSPF we use the command "enable ospf originate-default always cost 1 type ase-type-1" but I'm not finding a similar one to OSPFv3.

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN