Stacking time different on slot 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-22-2015 12:12 PM
Hi,
We have three switches in a stack, slot 1, slot 2 and slot 3. The time is the same on slot 1 and slot 3 if a telnet to slot 1 and slot 3 and show switch. But if I telnet to slot 2 and do a show switch the time is different and there is no time zone.
How do I sync the time between all three slots?
Thanks
Ian
We have three switches in a stack, slot 1, slot 2 and slot 3. The time is the same on slot 1 and slot 3 if a telnet to slot 1 and slot 3 and show switch. But if I telnet to slot 2 and do a show switch the time is different and there is no time zone.
How do I sync the time between all three slots?
Thanks
Ian
12 REPLIES 12
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-14-2016 04:33 PM
Hi Brad,
What recomendation should I follow, do I have to do an upgrade to 16.1.1 or a downgrade?
What recomendation should I follow, do I have to do an upgrade to 16.1.1 or a downgrade?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-14-2016 04:33 PM
Hi Jhonn,
15.7.2 came out after your 15.7.1 patch 1-2 so that would be the version that I would recommend. As always, with any version of code, it should be tested in a pre-production environment and then rolled out when sufficient testing has been completed in order to help mitigate against any unforeseen circumstances.
Brad
15.7.2 came out after your 15.7.1 patch 1-2 so that would be the version that I would recommend. As always, with any version of code, it should be tested in a pre-production environment and then rolled out when sufficient testing has been completed in order to help mitigate against any unforeseen circumstances.
Brad
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-12-2016 03:24 AM
Hi Jhonn,
The defect has been resolved in the following versons:
The defect has been resolved in the following versons:
- EXOS 16.1.1
- EXOS 15.7.2
- EXOS 15.6.2 Patch 1
- EXOS 15.5.4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎03-11-2016 05:04 PM
Hi, I have 4 switches Summit X460 in stack mode, master and backup are time synchronized but the other stanby nodes are out of time. I use the version 15.7.1.4 patch1-2. what action do I have to do in order to fix this?