Troubles with vlan 1 between extreme and cisco

[popeye]

Hello everyone.
I on my Cisco Nexus 3064 and Extreme x650-24x configured 6 * 10G ports etherchannel. Then I built trunk on cisco and added tagged vlans on extreme. Everything is ok despite of vlan 1. I can't get traffic in vlan 1 although there are mac addresses in this vlan.
Who has any ideas?
Thank you.

Cisco config:
 

cisco# sh running-config interface port-channel 50interface port-channel50  speed auto  priority-flow-control mode off  lacp graceful-convergence  no lacp suspend-individual  lacp min-links 1  lacp max-bundle 32  no port-channel port load-defer  lacp fast-select-hot-standby  no switchport block unicast  no switchport block multicast  no hardware multicast hw-hash  no hardware vethernet mac filtering per-vlan  switchport  switchport mode trunk  no switchport monitor  no switchport dot1q ethertype  no switchport priority extend  switchport trunk allowed vlan 1,11,111  spanning-tree port-priority 0  spanning-tree cost auto  spanning-tree link-type auto  spanning-tree port type normal  no spanning-tree bpduguard  no spanning-tree bpdufilter  logging event port link-status default  logging event port trunk-status default  duplex full  flowcontrol receive off  flowcontrol send off  no negotiate auto  mtu 1500  delay 1  snmp trap link-status  bandwidth 60000000  no bandwidth inherit  storm-control broadcast level 100.00  storm-control multicast level 100.00  storm-control unicast level 100.00  no storm-control action  no shutdown lan  load-interval counter 1 30  load-interval counter 2 300  no load-interval counter 3  medium broadcast  no shutdown

[popeye]

Thank you. I’ll check it.

[PeterK]

then you should check spanning tree behavior on both sides.

[popeye]

On extreme I configured only vlans and sharing:

enable sharing 41 grouping 41-46 algorithm address-based custom lacpconfigure vlan "Default" add ports 41 tagged

[PeterK]

ok, then you should share the config of both sides. Otherwise it’s difficult to find the reason

When the ports go down, it sounds a bit like a stp issue