cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to reload EXOS on X440-G2 prior member of a stack

Unable to reload EXOS on X440-G2 prior member of a stack

dcsdne
New Contributor III
When I run a config no in the bootloader it does not clear the config so I am attempting to reload the firmware

I believe I am following the proper steps to reload the firmware on this switch to default it. Unable to though.




BootRom > download image usb summitX-31.5.1.6.xos
(Re)start USB...
Starting the controller
Starting the controller
scanning usb for storage devices... 1 Storage Device(s) found
reading summitX-31.5.1.6.xos
Uncompressing ...


External Memory Card Rescue
Using External Memory Card file: summitX-31.5.1.6.xos


Rescue mode will always download and install a new image.
Rescue options:
1) format disk before install (ERASE ALL DATA)...."true"
2) clear NVRAM after install......................"false"

c) continue
r) reboot
~> 2
rescue_clear_nvram=true

Rescue mode will always download and install a new image.
Rescue options:
1) format disk before install (ERASE ALL DATA)...."true"
2) clear NVRAM after install......................"true"

c) continue
r) reboot
~> c
Ok to continue? (Y/N) y
**** Starting External Memory Card device
udevd: /extr/bin/udev.sh: line 18: udevd: not found
/extr/bin/udev.sh: line 23: udevadm: not found
/extr/bin/udev.sh: line 24: udevadm: not found
**** The specified rescue image - summitX-31.5.1.6.xos - could not be found.
The rescue process will now abort.
***** press ENTER to reboot:
1 ACCEPTED SOLUTION

CThompsonEXOS
Extreme Employee
It looks to not like something regarding that USB.

Are you trying to deploy this prior member of a stack as a standalone switch?   If so, when you boot in to EXOS are you stuck at "PENDING-AAA"?

If so you may be able to use "REBOOT AS MASTER-CAPAPBLE" as mentioned below.

 
https://extremeportal.force.com/ExtrArticleDetail?an=000077990

Also, if you have console access GTAC may be able to assist.

Using the mgmt port and a tftp server like below should also confirm it is something local to that USB:
https://extremeportal.force.com/ExtrArticleDetail?an=000083135

Thanks,
Chris Thompson

View solution in original post

2 REPLIES 2

dcsdne
New Contributor III
Went the TFTP Method to reload the Firmware and that worked.

CThompsonEXOS
Extreme Employee
It looks to not like something regarding that USB.

Are you trying to deploy this prior member of a stack as a standalone switch?   If so, when you boot in to EXOS are you stuck at "PENDING-AAA"?

If so you may be able to use "REBOOT AS MASTER-CAPAPBLE" as mentioned below.

 
https://extremeportal.force.com/ExtrArticleDetail?an=000077990

Also, if you have console access GTAC may be able to assist.

Using the mgmt port and a tftp server like below should also confirm it is something local to that USB:
https://extremeportal.force.com/ExtrArticleDetail?an=000083135

Thanks,
Chris Thompson
GTM-P2G8KFN