When I run a config no in the bootloader it does not clear the config so I am attempting to reload the firmware
I believe I am following the proper steps to reload the firmware on this switch to default it. Unable to though.
BootRom > download image usb summitX-31.5.1.6.xos
(Re)start USB...
Starting the controller
Starting the controller
scanning usb for storage devices... 1 Storage Device(s) found
reading summitX-31.5.1.6.xos
Uncompressing ...
External Memory Card Rescue
Using External Memory Card file: summitX-31.5.1.6.xos
Rescue mode will always download and install a new image.
Rescue options:
1) format disk before install (ERASE ALL DATA)...."true"
2) clear NVRAM after install......................"false"
c) continue
r) reboot
~> 2
rescue_clear_nvram=true
Rescue mode will always download and install a new image.
Rescue options:
1) format disk before install (ERASE ALL DATA)...."true"
2) clear NVRAM after install......................"true"
c) continue
r) reboot
~> c
Ok to continue? (Y/N) y
**** Starting External Memory Card device
udevd: /extr/bin/udev.sh: line 18: udevd: not found
/extr/bin/udev.sh: line 23: udevadm: not found
/extr/bin/udev.sh: line 24: udevadm: not found
**** The specified rescue image - summitX-31.5.1.6.xos - could not be found.
The rescue process will now abort.
***** press ENTER to reboot: