Upgrade Image

[Wee_Hong_Leong]

Hi,



I have a switch X440-48P running on image ver 15.2.1.5 on both Primary and Secondary and the use image was on Primary.

I have perform a firmware upgrade on the Secondary to image ver 15.3.1.4 and when the installation completed I selected use image Secondary and reboot the switch.



However, the LAN connection that was connected to this switch did not went up when the switch is up.

But when I selected back to the Primary and reboot the connection came back up.



Could you kindly advice what could be the problem?

[Wee_Hong_Leong]

As the new switch is running on image ver 15.3.1.4 Patch 1-19. I have downloaded the same image and installed into the existing switch in prepare for stacking.

[Wee_Hong_Leong]

The switch is not under stack at this moment but eventually it will. This is the reason that i'm upgrading the firmware as i have a new switch that both Primary and Secondary parition is running on 15.3.1.4 Patch 1-19

[PARTHIBAN_CHINN]

Hello Wee,

we need to do live troubleshooting in these cases.
What is the 15.3.14 patch u have in secondary partition.

Is it the latest patch.

You might be hitting known issues.

Regards,
Parthiban Chinnaya

[Bharathiraja__S]

Hi Wee,

Is this switch under stack ?

Thanks,
Suresh.B