X440 48t-10G multiast table full

[Ghezzi_Alberto]

I have this problem, sometime the Multicast table are full, and i must do reboot the switch to clean the table. Is there another way to don’t reboot? Maiby acl?

Or have you other ideas?

The erros are these:

10:02:59 Kern.IPv4Mc: IPv4 multicast entry not added.  Hardware L3 Table full. (Logged at most once per hour.)

09:19:15 Kern.IPv4Mc: Unable to Del L3 1:25 from s,G,v=a640102,effffffa,10 IPMC 2, unit 1 Entry not found

09:12:42 Kern.IPv4Mc: Unable to Del L3 1:25 from s,G,v=a640102,effffffa,10 IPMC 2, unit 1 Entry not found

09:01:57 Kern.IPv4Mc: IPv4 multicast entry not added.  Hardware L3 Table full. (Logged at most once per hour.)

08:50:56 Kern.IPv4Mc: Unable to Del L3 1:20 from s,G,v=a640105,effffffa,10 IPMC 2, unit 0 Entry not found

Thanks a lot

Alberto

[Alexandr_P · Accepted solution]

https://documentation.extremenetworks.com/exos_30.1/downloads/GUID-C002AB85-A1D6-482B-A171-02FDA1354...

Section - Multicast Routing and switching.

Thank you!

[Ghezzi_Alberto]

I have standard license - EDGE.

Can you better explain about CRP and CBSR ?

I enabled only IGMP protocol .

Thanks

[Alexandr_P]

Hello!

Based on license level.

• standard license for X440 - Edge - there is no PIM support
• upgrade - Adv Edge - PIM-SM-Edge

PIM Edge Mode is a subset of PIM that operates with the following restrictions:
• The switch does not act as a candidate rendezvous point (CRP).
• The switch does not act as a candidate bootstrap router (CBSR).
• At most, four active PIM-SM interfaces are permitted. There is no restriction on the number of
passive interfaces (within the limit of the maximum IP interfaces).
• Only PIM Sparse Mode (PIM-SM) is supported.

Thank you!

[Jacynthe]

Not seeing the "config pim" option on the X440. As I am not savy with extreme os and product line is this switch able to be a querier / RP?

IndigoCard Login