Configuration for a Summit 200 Series and VMware teaming
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2019 10:58 AM
Hello everyone.
I have an environment with one vmware server with 2 NICs configured as teaming connected to a switch. It seems that all traffic is going only through one of the ports.
If a do a cable test on the switch (a 220-48t-10GE4) it says always cable fail in one of the ports. Of course I tested the cables and the ports of the server and everything is fine.
I guess I need to configure the 220 properly.
In other switches, summit 400 series for example is very easy, you can use this comand: enable sharing grouping algorithm address-based L3_L4
But with 220 series this command does not works.
Do you know the equivalent to this command in a 220 series?
Thanks in advanced.
I have an environment with one vmware server with 2 NICs configured as teaming connected to a switch. It seems that all traffic is going only through one of the ports.
If a do a cable test on the switch (a 220-48t-10GE4) it says always cable fail in one of the ports. Of course I tested the cables and the ports of the server and everything is fine.
I guess I need to configure the 220 properly.
In other switches, summit 400 series for example is very easy, you can use this comand: enable sharing grouping algorithm address-based L3_L4
But with 220 series this command does not works.
Do you know the equivalent to this command in a 220 series?
Thanks in advanced.
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2019 12:32 PM
Thank you.
I'll take a look
I'll take a look
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2019 12:11 PM
https://documentation.extremenetworks.com/200_commands/downloads/GUID-D60A18E3-9453-4EF5-A1D6-F96235...
Page#382 for the CLI commands
Page#382 for the CLI commands
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎02-12-2019 12:08 PM
