Configuration of static dhcp binding on d-serie Switch don ́t work

[info_systemhaus]

i Need to config some dhcp Clients on my D2G124-12P with a different Gateway ... all Clients are in the same subnet .

Following Config don´t work :

set dhcp enable
set dhcp exclude 192.168.46.2 192.168.46.10
set dhcp exclude 192.168.46.199 192.168.46.254

set dhcp pool kolbe
set dhcp pool kolbe lease 0 12 0
set dhcp pool kolbe dns-server 192.168.46.254 8.8.8.8
set dhcp pool kolbe default-router 192.168.46.254
set dhcp pool kolbe network 192.168.46.0 255.255.255.0
set dhcp pool kolbe option 78 hex 01c0.a82e.03

set dhcp pool ap-gs10
set dhcp pool ap-gs10 dns-server 192.168.46.2
set dhcp pool ap-gs10 default-router 192.168.46.2
set dhcp pool ap-gs10 hardware-address 50:26:90:18:ed:1e
set dhcp pool ap-gs10 host 192.168.46.195 255.255.255.0

I tried this of course already with "dhcp pool client iedentifier" Option ..
i tried this with the dhcp hardware-adress Option

.. but nothig works, the Client everytime gets an address from pool "Kolbe"
the Standard pool. It´s not possible to work with a static dhcp entry.

Of course i tried different devices .. with wireless and wired Interfaces .. nothing works.

is anybody here who has successful config a D-Series Switch with such static dhcp bindings ?

Chassis Serial Number: 13260009905Y
Chassis Firmware Revision: 06.03.13.0001



Thanks



Christian

[Ronald_Dvorak]

Here with dynamic pool & static binding, as you'd see from the "show dhcp binding" it works...
!
set dhcp enable
set dhcp exclude 10.12.0.1 10.12.0.50
set dhcp exclude 10.12.0.70 10.12.0.254
!
set dhcp pool dynamic
set dhcp pool dynamic network 10.12.0.0 255.255.255.0
!
set dhcp pool static
set dhcp pool static client-identifier 01:20:b3:99:85:14:b5
set dhcp pool static host 10.12.0.60 255.255.255.0!!
!

D2_desk(su)->show dhcp bin
IP address Hardware Address Lease Expiration Type
10.12.0.51 00:1a:e8:14:11:3e 00:23:58 Automatic
10.12.0.60 20:b3:99:85:14:b5 00:23:56 Manual

I run the same version as you've installed on your D2.

[Ronald_Dvorak]

Hi Chris,

I've tried only the static part of the configuration and it looks like that the command "set dhcp pool XXX hardware-address" isn't working.

Use the "set dhcp pool XXX client-identifier" instead.

Here my example...
set dhcp pool test
set dhcp pool test client-identifier 01:20:b3:99:85:14:b5
set dhcp pool test host 10.12.0.33 255.255.255.0

The identifier is the MAC of the client with a 01 (=ENet address) in front.
So my MAC was 20:b3:99:85:14:b5 and I've put the 01 in front to create the ID 01:20:b3:99:85:14:b5

Hope that works for you.

Ron