Error Message in Logging Buffer
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-09-2014 10:42 AM
What does the following message means in logging buffer. System is a S-Series Device with Firmware Version 8.21.02.0001
Dune[5.dTcmTask]Petra[0] Received Interrupt PB_IRE_BURST_ERR_FOLLOW_SOP_IS_ERR instance 0, count 2, value= 0x1
Dune[5.dTcmTask]Petra[0] Received Interrupt PB_IRE_BURST_ERR_FOLLOW_SOP_IS_ERR instance 0, count 2, value= 0x1
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-07-2015 04:09 PM
Nico, let us know if you have any follow up questions on this topic or if this answer is sufficient for you.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-29-2015 01:18 PM
I am also getting the same message on logging buffer, in addition I get:
Received Interrupt PB_NIF_SRD_LANE_INT from slot 6 (fuji 4), count 0, value= 0xc0
Received Interrupt PB_MAL_LINK_STATUS_CHANGE_INT from slot 6 (fuji 4), count 6, value= 0x1
Received Interrupt PB_MAL_RX_PCS_LN_SYNC_STAT_CHANGE_INT from slot 6 (fuji 4), count 6, value= 0xc
Received Interrupt PB_NIF_SRD_LANE_INT from slot 6 (fuji 4), count 0, value= 0xc0
Received Interrupt PB_MAL_LINK_STATUS_CHANGE_INT from slot 6 (fuji 4), count 6, value= 0x1
Received Interrupt PB_MAL_RX_PCS_LN_SYNC_STAT_CHANGE_INT from slot 6 (fuji 4), count 6, value= 0xc
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎05-09-2014 11:15 AM
This message was previously reported with S-Series firmware 8.21.02.0001, related to a VSB port in transition to up or down.
After engineering review; it is deemed to be informational only, does not indicate a problem, and the logging will be corrected - probably suppressed - in a future firmware release.
After engineering review; it is deemed to be informational only, does not indicate a problem, and the logging will be corrected - probably suppressed - in a future firmware release.
