Hi all! What is different between LACP or a static algorithm??? Please advice.

[Paul11]

What is different between LACP or a static algorithm?

enable sharing port 47 grouping 47,48 L2 or L3

Kindly advise.

[Paul11]

And how can we prevent if Loop occur. Unplug the link and remove config? Or it will still creating a Network loop? thanks.

[PARTHIBAN_CHINN]

You should have the same lag configured on the peer switch. Once that's done u can connect both the links. If there is a misconfiguration then there is possibility of loop . But it's just one liner. Also u should add necessary vlans to the master port 47 to carry traffic

[Paul11]

hi how to add necessary vlans to the master port 47 to carry traffic?

[Paul11]

Thanks PARTHIBAN,

Can you please provide the command to check after the LAG configuration done at both switches?

Is it load sharing using 2 Link or only using Master port?

And how can we prevent if Loop occur. Unplug the link and remove config? Or it will still creating a Network loop?

Please advice.

[PARTHIBAN_CHINN]

Hi Lacp is for interoperability between multiple vendors. Lacp is Ieee standard. Lacp can more than 8 links which can be standby Static lag has its own limitations based on vendor. The above config u made is static lag