ExtremeSwitching (Other) - Page 29 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Does 210 series support Ipv4 to IPv6 Transition Mechanism (Dual Stack on HP 2530) and Virtual Stacking (Virtual stack is a technology that provides centralized management for up to 10,000 switch ports.)?

I am checking 210 series specs against the HP 2530 which says it support Dual Stack and Virtual Stacking that says it can provide centralized management for up to 10,000 switch ports. Which confuses me because when you say stacking the stacked switch...

How to replace a failed switch in a stack?

I have two x460-48t switches configured in a stack. I want to create a procedure for replacing one of them if it fails. I searched and found a similar question from a year ago. But the document that was offered as a solution is no longer available to...

Resolved! Additional LAG ports in a stack

Hello.I am new to the community and this is my first post.I am considering placing an older X450e-24p in an area where I need 12 additional switch ports (4 ports need PoE). The edge stack consist of four X440G2-48p switches and has LAG ports going to...

Resolved! configuring eth ports

HelloI have an AP330 and I have successfully configured it as a WIFI access point. I would also like to configure eth0 and eth1 as follows:I would like to connect eth0 to my router (which is also a DHCP server)I would like to connect eth1 to my deskt...

Resolved! B5 and S-Series switch policy profile with multiple rules

I’m assuming this is possible but I’m not sure how to do it.For example based on the GTAC guide “How to Block Bonjour traffic with Policy via Command Line Interface” I know how to drop this IPv4 traffic.I would like to add to this existing rule anoth...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN