How send a SNMP Traps test to the Network Management?

[Luis_Melendez]

Hi All,

I am working on the integration of Extream Network 450a switch to the Network Management system, the integration is already done, but we want to make some test, Can you please let me know how can I test this traps?

Thank you so much in advanced

Luis Melendez

[Bin]

Hello Luis,

Are you using Extreme Management Center as Network Management system?

If yes, you could reference to the following script
Netsight: How to configure a summit switch to send a SNMP v3 trap to Netsight, and have Netsight correctly log the trap for that switch
https://gtacknowledge.extremenetworks.com/articles/How_To/Netsight-How-to-configure-a-summit-switch-...

Best regards,
Bin

[Luis_Melendez]

Hi All, Thank you so much for your answers.... The SNMP configuration on the switch is done, I am looking for a way to send a trap for test.

Best Regards

Luis Melendez

[Ram3]

Use the command "show management" and check the counter "SNMP traps" is increased.

Please use the below url to download the MIB Browser Personal Edition (3rd party):
http://www.ireasoning.com/download.shtml

After installing, go-to tab Tools -> Trap receiver -> then initiate a port UP/DOWN from switch trap and you will see the SNMP traps in ireasoning tool.

[Ram3]

Please log into the switch and type in the following command:
“configure snmp add trapreceiver community ”

If no SNMP trap receiver is configured, EXOS will not send traps. Use command "show configuration snmp" and "show management" output to see the trap receiver is configured.