cancel
Showing results for 
Search instead for 
Did you mean: 

SNMP to CISCO

SNMP to CISCO

premgin
New Contributor
Hi , we have a ups in the racks which needs to be connected to the network via snmp through a Cisco switch. When directly connected via Cat6 cable to the network we can access ups detail via web browser. Instead of connecting to switch directly we used a hub in between and it's getting connected . But when we try to connect via switch it's not happening. An IP address is already allocated and has been configured in the UPS. We have even tried adjusting switch port speed. Please advise how to resolve .
3 REPLIES 3

Roger_Green
New Contributor
do a show snmp on the switch. make sure it is enabled

You can try using MibTools in Netsight Console to see if it replies with any of the profiles you have for the device. It may be that a new profile with SNMP credentials unique to the device needs to be created.

You may want to review this article.
https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-and-Use-Netsight-Authorizatio...

Zdeněk_Pala
Extreme Employee
Do you see port up? What about port speed and negotiation? What about duplex? Do you see the MAC learned on the switch port? Is it in correct VLAN?
Regards Zdeněk Pala
GTM-P2G8KFN