cancel
Showing results for 
Search instead for 
Did you mean: 

stacking problem in X670-G2

stacking problem in X670-G2

omar_khaled
New Contributor

Hi There

We have two X670G2-48x-4q and want to stack them to each other. we use V160 and easysetup according to following document. (EXOS version, License Level and Active Partition are same)

https://extremeportal.force.com/ExtrArticleDetail?an=000080493

we encountered some problems. after enable stacking switches (some time one of switches) crashes and goes reboot.

some of logs listed here:

unconfigure dispatch attach fail: bcm_attach client unit 9
Unable to set ECMP hash= 0 for slotNo 2 unit 9, â 0 rc -19
Slot-1: Slot-2 down, resetting all TCP connections to it
Slot-1: Module in Slot-2 is removed
Slot-1: initBCMChipTempSensors : Failed to initialize chip temperature sensors for slot Slot-2
Slot-1: ERROR4: attaching driver to slotNo 2 unit 0 remote 9, rc=-19
Slot-1: Unable to set L2/L3 Hash = 5 for slotNo 2 unit 9, rc -19

default EXOS version is: 15.6

we cleared NVRAM, upgraded to EXOS 16.1.3.6-patch1-9 and 16.1.3.1-Patch1-7 but again not works (crash and reboot).

please tell us which EXOS is compatible with stacking and what we should do.

Regards.

7 REPLIES 7

Erik_Auerswald
Contributor II
Hi Chacko,

EXOS 16.1 is currently recommended for the X670-G2 switches, but the new 21.x and 22.x versions can be used as well.

Please see http://www.extremenetworks.com/extreme-hardwaresoftware-compatibility-recommendation-matrices/softwa...

Erik

Chacko
Contributor
Dear Omar,

is it right, that you use the 16.1.3.6 on the X670-G2?
I think only the new 21.X or higher is supported on that one.

Best Regards
Chacko

Jason_Parker
Contributor
Do all of the switches contain all the same licenses Have you tried building a stack with just with the.same image installed ( no configuration at all)

Could you please open a GTAC case? So we could analyze/troubleshoot further.
GTM-P2G8KFN