Summit enable sharing 25 group 25-26 lacp 25 is the lead port To check status show port sharing Example:
code:* X150-24p.41 # show port sharingLoad Sharing MonitorConfig Current Agg Ld Share Ld Share Agg Link Link UpMaster Master Control A...
I followed your commands displayed, (210-24.cfg) (Config)#interface 0/1,(210-24.cfg) (Interface 0/1)#poe,(210-24.cfg) (Interface 0/1)#shutdown , all that last command did was disable the interface 0/1 but poe was still available at the port-
(210-24....
You can start with enable
config
poe reset
This should reset all port settings.
Could you confirm the switch "show hardware" or firmware "show bootvar"
