04-20-2017 02:29 PM
We have been running the summit x460 for almost 4 years in a stack and suddenly that one from that stack comes down, and we weren't able to start up it again, and when we put the serial cable to indentify what was going on with that we could see this one was showing the follow error in the link below.
Nonetheless we have followed what the procedure is saiying but not successful. We have tried to install the image summitX-16.xxx and even so, after installed the switch rebooted but that failure still happening.
I'm a quite concerned with the possibility that fault is happening due hardware failure, because it would take a long time to be fixed, or replaced that one.
Does someone else have any ideia?
Everything from you will be appreciated.
04-24-2017 01:28 PM
04-21-2017 12:20 AM
04-20-2017 02:39 PM
04-20-2017 02:37 PM