ExtremeSwitching (Other) - Page 56 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Switch leaving a Stack with ports Up

Hi, We have two stacks, each is made with 2 X670V-48t and 1 X670V-48x. Stacking has been done using alternate ports 47 and 48. Therefore 10G ports 45 and 49 on X670V-48t cannot be used. No VIM. Ports 45 to 48 are put as x in figure below: We need t...

ISW Stacking Support?

As luck would have it, I have a requirement for more ports than my ISW allow. I have two ISWs and am prepared to build out two of them for my needs- but wanted to know if I could stack them? I don't believe so, but thought I might ask.

Unable to login extreme 220 series unit-1 switch in stack mode

Hi Team, I have connected 3 extreme 220 switches in the stack, but unable to login unit-1 switch. How to make the switch as a master, standby, member.

igmp snooping & vlan routing Extreme 220

The admin guide for the Extreme 220 says "If an interface has IGMP Snooping enabled and you enable this interface for routing or enlist it as a member of a port-channel (LAG), IGMP Snooping functionality is disabled on that interface." Does this mean...

SNMP version v2c & v3 simultaneously on ISW 8GBP 4SFP

Hi Extreme Community ! I have a problem with my ISW 8GBP configuration. I'd like to use snmp version v2c and v3 simultaneously but I did no find out how to do it or if is this possible ? On web interface, we can only choose between one or the other....

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN