Good day, ers3500 does not enable slpp-guard, in the log: % Cannot modify settings % SLPP-guard not enabled on port 1 - no filters / filter precedences available. At the same time, on the ers3600, the ers5500 turns on and works. Please tell me what t...
Unsuccessfully cannot get an adjacency in GNS3 VOSS 7.0 using Fabric Extend over IP Tunnel using loopbacks. Can anyone advise where I’m going wrong here? I think my logic is correct, but maybe the config is not? I need to implement this for a custome...
This simple question, I know how to do by CLI but I was wondering if it is posible to check via GUI interface. Regards!
We recently installed stacks of the 4950's and over the past few weeks they are repeatedly failing and breaking to form individual switch units. The current spec is HW: 11, FW: 7.5.0.2, SW: v7.5.0.007. Spanning tree and SLPP are both configured on un...
In this case looping on new port between Firewall and Core-Switch. Could you please advise for configure on core-switch.
