ExtremeSwitching (VSP/Fabric Engine) - Page 37 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Superseeding a direct route with a static route in VOSS

Hi all.I'm curious about if it's posible to make a static route better than a direct route in VOSS 8.2. In my setting we have a VLAN with the gateway *outside* the switch but with an IP configured in the switch VLAN interface, so there is a local dir...

What type of connector is supported in Extreme SFP module?

Hi, Is there any official recommendation what type of connector I should use in Extreme SFP modules? I suppose I should use LC UPC, but can I use LC APC? I could not find any statement in Extreme documentation but for example Cisco doesn't support LC...

Resolved! NNI as a DCI - Best practice

Does Extreme have any best practices for DCI links configured as NNI's for a pair of 8404's?These NNI's will be be connecting BCB's, So at this point of time they are strictly just transit nodes and are not doing any L3 features for the network, VRRP...

BCB VS BEB

Can a BCB have UNI ports and still work as a BCB?

Unable to connect to CLI in read-only mode via Radius

Hi,I'm facing an obvious problem trying to allow CLI RO connection to FabricEngine devices using Radius on XIQ-SE.All is working fine for RWA access, and my setup is similar for RO access, except for Access control profile on XIQ-SE, for which policy...

Top Kudoed Authors

User

Count

32

18

16

15

7

GTM-P2G8KFN